« Indy '06 Prep | Main | Air Compressor »
May 15, 2006
Indy '06 Prep - Final Day
Still need to get:
Two Deltagate wastegate gaskets
2.5 to 2" reducer
Replace bent steering center link (and might as well do tie rods too...)
Exhaust gaskets - 2 hole 2.5" dia (appx. 4" between bolts) and 3.5" dia. 3 hole, with 3.75" between bolt centers
Still need to do:
Replace center link, idler arm and tie rod ends, and align car
Fab throttle linkage and cable end
Add oil, rear end, and tranny fluid (and check power steering fluid once started)
Flush brake fluid
Wire oil pressure warning light and replace positive connector to ECM panel
Weld beaded 3" duct ends onto brake ducts
Connect intake piping
Bolt on wastegates
Modify exhaust for side exit and bolt on y-pipe
Set 3 link angle and tighten bolts
Cornerweight (if time)
remove wiper idler arms
Protect -12 lines from chafing by radiator
Install pass seat and harness
Tie spark plug wires away from downpipes
Pack Durango
Replace trailer connector
Connect trailer e-brake battery
Check wheels, axles, and fenders
Change durango oil & check coolant/ATF
Set up video camera
Prep laptop with data acquisition software and wiring diagrams
Wash car?!!
Posted by Z28tt at May 15, 2006 9:58 AM